Today in lab, we have gone over our results with the stress analysis. A myriad of gears were tested to show the strength in the teeth. These results will be used for more modifications to ensure the highest quality in our prototype.
After the analysis, the part will show points that are being under the most stress. A way to fix this is to add rounds that connect the teeth to the base of the gear itself. This will add extra support which can make the gear run under even more force when needed. This will greatly enhance the performance.
After the analysis, the part will show points that are being under the most stress. A way to fix this is to add rounds that connect the teeth to the base of the gear itself. This will add extra support which can make the gear run under even more force when needed. This will greatly enhance the performance.
No comments:
Post a Comment